Content
- The 2 most common problems with the grass trimmer thread - Tips & Tricks
- Mowing thread breaks - Tips for causes and problem solving
- Mowing thread is not coming - so it gets going again
- Tips
If wet grass is trimmed, the thread can tear
The 2 most common problems with the grass trimmer thread - Tips & Tricks
If the grass trimmer does not work, usually a thread problem is the root of all evil. There are mainly two complications that rob the annoyed gardener the last nerve. Find out what these are and how to eliminate the defect yourself here.
Mowing thread breaks - Tips for causes and problem solving
A demolished mowing thread undisputedly leads the inglorious ranking of frequent grass trimmer problems. What causes the annoyance with tips for solving the problem, we have summarized below for you:
An incorrect winding technique causes the cutting line to break. Do not lay the thread too tight or too loose around the bobbin. In a double thread, the halves must not cross each other. Each half of the thread should be wound up in its spool groove so that the material does not get caught and torn.
Mowing thread is not coming - so it gets going again
Most grass trimmers have a mechanical automatic, so that a sufficiently long thread is always available. If the mower thread is too short, tap the mower head briefly on the ground while the engine is running. The thread brake releases and releases a piece of the mowing wire. If this thread automation does not work, please check the device for the following reasons:
Edged grass trimmer threads do not use as quickly and tear less frequently. However, the threads often jam in the coil. Choose a round, smooth cutting line, causing the automatic replenishment of rare problems.
Tips
Grass trimmers with 2-stroke motor often cause annoyance to the gardener, because the device does not start. If gasoline shortage can be excluded as a cause, please check the condition of spark plug and air filter. For a cold start push the choke in. When the engine is warm, please remove the choke for your brush cutter to start.