Content
- Plant the branch of a corkscrew willow - this is how a shrub will turn out
- The right cut is the key - That's how it works
- Plant the branch skillfully
- Tips
The corkscrew willow can be easily multiplied
Plant the branch of a corkscrew willow - this is how a shrub will turn out
In each branch of a corkscrew pasture is the power for another magnificent shrub. Therefore, do not throw off vital branches after pruning. With a few simple steps, the branch is prepared for the plywood and planted. This guide explains step-by-step how to do it right.
The right cut is the key - That's how it works
It is an interaction of various factors that motivates a corkscrew branch to a strong rooting. A decisive contribution is made by the well thought out cut. Only when the polarity is preserved, the desired root strands sprout. This is how it works:
In order to set the branch in the correct orientation in the future in the earth, the lower section is set at an angle. On the other hand, the shoot tip is cut straight away so that a mistake can be ruled out. Incorporated offshoots do not root upside down.
Plant the branch skillfully
To set a corkscrew branch professionally in the ground, you have 2 options. If your garden is in a wintry region, put the pruned twig in a pot of peat sand. Situated in a light, frost-free room, pour only minimal, so that the substrate does not dry out. From spring on, take care of the plywood in the partially shaded place on the balcony until a strong root system has developed.
In situations without too much frost, you are free to plant the corkscrew twig immediately into the ground. At the sunny to partially shaded spot, drill a planting hole with the stick to insert the plywood two-thirds into it. After you've finished the planting, spread a thick layer of leaves over it until spring.
Tips
One-year branches of a corkscrew pasture not only act as growth-friendly sticks for propagation. The growth hormones contained therein provide an excellent accelerator for rooting. Just cut into pieces, bring to a boil in water, let stand for 24 hours and strain. If seedlings of all kinds are cast with it, root growth really gets going.