Are you allowed to cut a Kentia palm?

Posted on
Author: Roger Morrison
Date Of Creation: 24 September 2021
Update Date: 11 May 2024
Anonim
Kentia Palm Care Made Easy (Essential Tips For A Healthy Plant)
Video: Kentia Palm Care Made Easy (Essential Tips For A Healthy Plant)

Content



When cutting the Kentia palm, pay attention to sharp cutting tools

Are you allowed to cut a Kentia palm?

Like all palm trees, Kentia palm trees are not cut back. When cutting the tip, the vegetation point would be removed, so that the palm can not continue growing and even enters. You may only cut brown, dried or sick leaves.

Previous article Repainting a Kentia palm tree properly Next article Multiply Kentia palm trees by seeds

Never cut up Kentia palms

The Kentia palm grows quite slowly, so it takes a while until it reaches a certain height. That's a good thing, because you should never cut the tip of a Kentia palm if you still want to enjoy the palm.

Only the fronds are cut and the roots are repotted when repotting:

If you want to cut whole fronds, you better wait until autumn. Then the palm will recover over the winter.

How to cut a Kentia palm properly

If the tips of the leaves are brown, simply cut them off. However, the cut must not lead to the healthy foliage, since the leaves dry out at these points later.


Discolored fronds will not be cut until they are completely dry. Only if many pests have spread on the palm, you should remove previously infected fronds before. Cut them directly off the trunk, leaving a stub of three to four centimeters. It frayed and gives the Kentia palm later the typical appearance.

Always use sharp tools to cut the fronds. Blunt blades tear down the interfaces and thus provide a breeding ground for bacteria, germs and fungi. Thoroughly clean the cutters before use so that you do not transfer any pests or diseases to the Kentia Palm.

Trim roots while repotting

If you want to slow down the growth of your Kentia palm, you can trim the roots as you repot the palm. Just cut off a few side roots. Do not hurt the long taproots. If these are damaged, the Kentia palm can enter.

Tips

Kentia palm trees are also good for hydroponic cultivation. However, you should only use plants that have been cultivated in the water from the beginning. Later, the palms can only be adapted badly.