Content
- Can I pull a rubber tree out of a cutting?
- How do I cut cuttings?
- How do I care for cuttings?
- The essentials in brief:
- Tips
The cuttings from the rubber tree should have at least a leaf and a bud
Can I pull a rubber tree out of a cutting?
For many hobby gardeners and plant friends is the reproduction is a big topic. Even pulled young plants are a special treat and a nice gift for other plant lovers. With a little patience, a rubber tree can be pulled out of a cuttings well.
How do I cut cuttings?
There are several ways to cut cuttings from your rubber tree. If the plant has become too big, then shorten the trunk to the desired height. Use the cut part as a cutting. If you want to rejuvenate your rubber tree at the same time, then Abmoosen is a good alternative.
You can also cut cuttings from side shoots. These should have at least a leaf and a bud and a length of at least six centimeters. Cuttings, which are cut in spring at the beginning of the growing season, grow best.
Be sure to use a sharp knife for thinner shoots and a pruner when cutting the trunk of your rubber tree. Gloves prevent the milky sap from touching your hands and possibly triggering an allergy. In addition, your tool should be clean so that no disease can be transmitted.
How do I care for cuttings?
Place the freshly cut cuttings in a glass of water until a large portion of the milky plant juice has drained off. Then put it in a pot with nutrient-poor substrate. Always keep it well wet, but not wet. This works best in a room greenhouse or under a transparent film.
In addition, your cutlery needs a lot of light, like any rubber tree. So put it in a bright place. After about three months you may slowly get your young rubber tree to normal room air by ventilating it.
The essentials in brief:
Tips
The setting of cuttings is the simplest way of propagating the rubber tree.